Table of Contents
Advertisement
2.
Disconnect the power adapter cable from the system board.
Reverse this procedure to install the power adapter cable.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display assembly, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the display assembly:
1.
Remove the WLAN shield (1).
The WLAN shield is available using spare part number M33459-001.
2.
Carefully disconnect the two antenna cables from the WLAN module (2).
3.
Release the WLAN antenna cables from the retention clip (3) built into the top cover/keyboard.
4.
Disconnect the webcam/microphone module cable (4) from the system board.
5.
Release the webcam/microphone module cable from the retention clips (5) built into the top cover/
keyboard.
6.
Release the adhesive strip (6) that secures the display panel cable to the system board.
7.
Disconnect the display panel cable (7) from the system board.
Preparation for disassembly on page
Bottom cover on page
27).
27).
Battery on page
29).
Display assembly
39
Advertisement
Table of Contents
