3.
Remove the Phillips M2.0 × 2.8 screw (3), and then remove the WLAN module (4).
NOTE:
antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable connects
to the WLAN module #1 Aux terminal.
4.
If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on the
antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Connector board cables
To remove the connector board cables, use this procedure and illustration.
32
Chapter 5 Removal and replacement procedures for authorized service provider parts
Models have either one or two WLAN antennas. On models with two antennas, the #1 white WLAN