Advertisement
MAINTENANCE
– Seal the oil and fuel lines on the
boat and on the outboard to pre-
vent leaks and prevent contami-
nants from entering the oil or fuel
system.
– Install shipping brackets to prevent
the outboard from turning.
– Cap steering fighting on the out-
board and hydraulic hoses to pre-
vent leaks and prevent
contaminants from entering the hy-
draulic system.
S S h h o o r r t t - - T T e e r r m m S S t t o o r r a a g g e e
If you must tilt the outboard to remove
it from the water, lower it and allow the
cooling system to drain completely as
soon as you clear the launch area. Be-
tween uses, store your outboard in a
vertical position.
L L o o n n g g T T e e r r m m S S t t o o r r a a g g e e ( ( W W i i n n t t e e r r i i z z a a t t i i o o n n ) )
W W A A R R N N I I N N G G
I I f f w w i i n n t t e e r r i i z z i i n n g g o o n n a a t t r r a a i i l l e e r r , , t t h h e e p p r r o o - -
p p e e l l l l e e r r m m u u s s t t b b e e r r e e m m o o v v e e d d b b e e f f o o r r e e
p p e e r r f f o o r r m m i i n n g g p p r r o o c c e e d d u u r r e e . . F F a a i i l l u u r r e e t t o o
r r e e m m o o v v e e p p r r o o p p e e l l l l e e r r c c a a n n c c a a u u s s e e p p e e r r - -
s s o o n n a a l l i i n n j j u u r r y y o o r r d d e e a a t t h h . .
Winterization prepares your outboard
for long-term off-season storage. Dur-
ing
winterization,
"fogged" with extra oil to coat internal
engine components.
Winterization requires a specific proc-
ess of steps.
N N O O T T E E : : The Evinrude ICON touch dig-
ital display provides a one-touch win-
terization. See the I I C C O O N N T T o o u u c c h h
U U s s e e r r ' ' s s G G u u i i d d e e .
Closely follow the applicable winter-
ization procedure for your outboard:
– Remote control
– Remote control with foot throttle
You can confirm your outboard enters
winterization mode when the engine
runs at fast idle and:
58
the
engine
is
– The ICON gauge will display a win-
terization message (if equipped).
– The SystemCheck gauge lights
flash (if equipped).
P P r r e e p p a a r r a a t t i i o o n n
Your outboard can be winterized in
the water. If winterizing in water, make
sure the water intake screens are
completely submerged.
1. Stabilize the engine's fuel supply.
Add 2 +4 Fuel Conditioner follow-
ing instructions on container. Fill
fuel tank.
2. If winterizing on a trailer, remove
the propeller. Attach a garden
hose to flushing port and turn on
the water. Refer to .
3. Turn the key switch to the OFF
position.
4. Move the lever (s) to the FOR-
WARD wide open throttle position.
B B I I N N N N A A C C L L E E M M O O U U N N T T C C O O N N T T R R O O L L ( ( S S H H O O W W N N ) )
5. Turn the key switch to ON and wait
a minimum of three seconds.
6. Attempt to start the outboard three
times within three seconds (the
starter will not engage or crank the
outboard).
7. Move the lever to NEUTRAL and
start the outboard(s).
8. Run the outboards at idle for a
minimum of three seconds.
9. With the outboard (s) running, at-
tempt to start the outboard three
times within three seconds (the
starter will not engage or crank the
outboard).
10. The remote control will send the
winterization message to each
Advertisement
