Advertisement
If your outboard does not react nor-
mally to this starting procedure or if it
fails to start, refer to .
A A f f t t e e r r E E n n g g i i n n e e S S t t a a r r t t s s
The engine monitoring system will
alert you of any abnormalities.
E E n n g g i i n n e e S S t t o o p p p p i i n n g g
Move the control handle to the NEU-
TRAL position.
M M u u l l t t i i p p l l e e E E n n g g i i n n e e A A p p p p l l i i c c a a t t i i o o n n s s : :
– Briefly push the STOP buttons.
T T Y Y P P I I C C A A L L ( ( D D U U A A L L E E N N G G I I N N E E S S H H O O W W N N ) )
1. Stop buttons
A A l l l l A A p p p p l l i i c c a a t t i i o o n n s s : :
– Turn the key switch counterclock-
wise to the OFF position.
1
1. Key switch OFF position
Remove the key when the boat will be
unattended.
R R e e m m o o t t e e C C o o n n t t r r o o l l s s — — E E v v i i n n r r u u d d e e
I I C C O O N N I I I I C C o o n n t t r r o o l l S S y y s s t t e e m m
I I M M P P O O R R T T A A N N T T : : For complete informa-
tion about using Evinrude ICON II™
R
1
remote control systems, refer to the
" Evinrude ICON II User's Guide".
R R e e m m o o t t e e C C o o n n t t r r o o l l S S e e l l e e c c t t i i o o n n
Evinrude ICON II is an intelligent,
electronic shift and throttle control sys-
tem for use with Evinrude E-TEC out-
boards. ICON II control systems are
available for up to four– engine instal-
lations. The Evinrude ICON II control
system supports dual station and "fly-
ing bridge" applications.
E E v v i i n n r r u u d d e e I I C C O O N N I I I I R R e e m m o o t t e e C C o o n n t t r r o o l l
F F e e a a t t u u r r e e s s
2
4
C C O O N N C C E E A A L L E E D D S S I I D D E E M M O O U U N N T T E E V V I I N N R R U U D D E E
I I C C O O N N I I I I C C O O N N T T R R O O L L
1. Trim/tilt switch
2. RPM switch panel (Optional)
3. OFF/ON/START switch
4. NEUTRAL Indicator LED (Optional)
1
3
2
S S I I N N G G L L E E B B I I N N N N A A C C L L E E E E V V I I N N R R U U D D E E I I C C O O N N I I I I
C C O O N N T T R R O O L L S S
1. Trim/tilt switch
2. Neutral button (full feature controls only)
3. Gear position indicator (full feature controls
only)
4. RPM tune button (full feature controls only)
OPERATION
3
1
2
1
31
Advertisement
