Advertisement
OPERATION
long, it can be shortened by knotting
or looping it. DO NOT cut and re-tie
the tether cord.
N N O O T T I I C C E E
C C a a r r e e f f u u l l l l y y c c h h e e c c k k t t h h e e f f u u n n c c t t i i o o n n o o f f a a l l l l
c c o o n n t t r r o o l l a a n n d d e e n n g g i i n n e e s s y y s s t t e e m m s s b b e e - -
f f o o r r e e l l e e a a v v i i n n g g t t h h e e d d o o c c k k . .
Move the remote control handle to
NEUTRAL.
1
D D O O N N O O T T advance the throttle before
start-up. Advancing the throttle over-
rides
the
electronic
system.
If the outboard is started with the throt-
tle advanced, the outboard will be in a
safety mode.
It will not respond to throttle until the
throttle is returned to slowest IDLE
position.
After the engine starts, the engine
management module ( EMM ) auto-
matically increases idle speed slightly.
Idle speed will decrease as the engine
warms up.
30
idle
control
E E n n g g i i n n e e S S t t a a r r t t i i n n g g
I I M M P P O O R R T T A A N N T T
Evinrude ICON II Remote Control
System, refer to .
Turn the key switch to the ON posi-
tion, then:
– S S i i n n g g l l e e e e n n g g i i n n e e a a p p p p l l i i c c a a t t i i o o n n s s — —
turn the key fully clockwise to the
START position.
– M M u u l l t t i i p p l l e e e e n n g g i i n n e e a a p p p p l l i i c c a a t t i i o o n n s s — —
Push and hold the START button
(s).
1. Key switch START position
1
T T Y Y P P I I C C A A L L ( ( D D U U A A L L E E N N G G I I N N E E S S H H O O W W N N ) )
1. Start buttons
Upon start-up, release the key or
buttons.
If the engine did not start, release the
key or button momentarily, then try
again.
Each time the key switch is turned
from OFF to ON, the warning system
will
self-test.
MONITORING .
:
If equipped with
1
1
Refer
to
ENGINE
Advertisement
