Usb Device Requirements; Connect A Usb Storage Device To The Extender - NETGEAR EAX80 User Manual

USB Device Requirements

The extender works with most USB-compliant external flash and hard drives. For the
most up-to-date list of USB devices that the extender supports, visit
http://kbserver.netgear.com/readyshare.
Some USB external hard drives and flash drives require you to load the drivers onto the
computer before the computer can access the USB storage device. Such USB storage
devices do not work with the extender.
The extender supports the following file system types for full read/write access:
• FAT16
• FAT32
• NTFS
• NTFS with compression format enabled
• Ext2
• Ext3
• Ext4
• HFS
• HFS+
Connect a USB Storage Device to the
Extender
ReadySHARE lets you access and share USB storage devices that are connected to the
appropriate extender port. (If your USB storage device uses special drivers, it is not
compatible.)
To connect a USB device:
1. Insert your USB storage device into a USB port on your extender.
2. If your USB storage device uses a power supply, connect it.
You must use the power supply when you connect the USB storage device to the
extender.
When you connect the USB storage device to the extender USB port, it might take
up to two minutes before it is ready for sharing. By default, the USB storage device
is available to all computers on your local area network (LAN).
Share USB Storage Devices
Attached to the Extender
Nighthawk AX8 8-Stream WiFi 6 Mesh Extender
57 User Manual