Looking For Blockages; Disposal Information - Dyson Cyclone v10 Operating Manual

• Stand both brush bars upright. Ensure that the large brush bar is stood
upright as shown. Leave to dry completely for a minimum of 24 hours.
• Before replacing, check that the brush bars are completely dry. Refit
the small brush bar before the large one. Insert the round end of the
small brush bar into place. Push down the octagonal end until it clicks
into place.
• Reattach the end cap to the brush bar.
• Slide the large brush bar back onto the cleaner head, around the motor.
The end cap should be in the open position as shown. Once in place,
rotate the end cap back into the closed position.
• The end cap should be in the open position as shown. Once in place,
rotate the end cap back into the closed position.
• Close the fastener by turning a quarter turn clockwise. Ensure that
the fastener is fully turned and that the base plate and the brush bars
are secure.
WASHING THE FILTER UNIT
Check and wash the filter unit, according to the instructions, to
maintain performance.
• Remove the filter unit by twisting anti-clockwise to the open position.
Gently pull away from the appliance.
• Wash the inside of the filter unit first; hold it upright under the cold water
top and agitate using a rotating motion.
• Wash the outside of the filter unit; fill the unit with cold water, place your
hand over the open end and shake gently.
• Repeat washing the inside and outside of the filter unit until the water
runs clear.
• Gently tap the filter unit to remove any excess water and leave to dry with
the open end facing up.
• Leave the filter unit to dry completely for a minimum of 24 hours.
• Check that the filter unit is completely dry.
• To refit, return the filter unit to the open position and twist clockwise until
it clicks into place.
The filter unit may require more frequent washing if vacuuming fine dust
or using mainly maximum suction.
Do not put the filter unit in a dishwasher, washing machine, tumble dryer,
oven, microwave or near a naked flame.
BLOCKAGES – AUTOMATIC CUT-OUT
• This appliance is fitted with an automatic cut-out.
• If any part becomes blocked the appliance may automatically cut out.
• This will happen after the motor pulses a number of times (i.e switches
on and off in quick succession) and the blockage indicator LED
will illuminate.
• Leave to cool down before looking for blockages.
• Ensure that the appliance is disconnected from the charger before
looking for blockages. Failure to do so could result in personal injury.
• Clear any blockage before restarting.
• Refit all parts securely before using.
• Clearing blockages is not covered by your Dyson guarantee.

LOOKING FOR BLOCKAGES

The motor will pulse and the blockage indicator LED will illuminate
when there is a blockage. Please follow the instructions below to locate
the blockage:
• Ensure that the appliance is disconnected from the charger before
looking for blockages. Be careful not to pull the 'ON' trigger.
• Do not operate while checking for blockages. Doing so could result
in personal injury.
• Leave to cool down before looking for blockages.
• Beware of sharp objects when checking for blockages.
• To check for blockages in the main body of the appliance, remove the
clear bin following the instructions in the cleaning the clear bin section
and remove the blockage.
• If you cannot clear an obstruction you may need to remove the brush
bars, please follow the instructions below:
– To remove the soft roller cleaner head brush bars, please refer to the
'Washing the brush bars' section. Remove the obstruction and replace
the brush bars as shown in the 'Washing the brush bars' section.
Ensure that the fastener is fully turned and the base plate and brush
bars are secure before operating the appliance.
– To remove the brush bar from the direct drive cleaner head or mini
motorised tool, use a coin to unlock the fastener and slide the brush
bars out of the cleaner head. Remove the obstruction. Replace the
brush bar and secure it by tightening the fastener. Ensure it is fixed
firmly before operating the appliance.
• This appliance has carbon fibre brushes. Take care if coming into contact
with them, as they may cause minor skin irritation. Wash your hands
after handling the brushes.
• Refit all parts securely before using.
• Clearing blockages is not covered by your Dyson guarantee.
CHARGING AND STORING
• This appliance will switch 'OFF' if the battery temperature is below 3°C
(37.4°F). This is designed to protect the motor and battery. Do not charge
the appliance and then move it to an area with a temperature below 3˚C
(37.4°F) for storage purposes.
• To help prolong battery life, avoid recharging immediately after a full
discharge. Allow to cool for a few minutes.
• Avoid using the appliance with the battery flush to a surface. This will
help it run cooler and prolong battery run time and life.
20
06.09.2017 07:40 - C87672_SV12_OPMAN_FEAST_X248-V10-ABSOLUTE-OPMAN-87672.indd_15_4c0s
BATTERY SAFETY INSTRUCTIONS
• If the battery needs replacing please contact the Dyson Helpline.
• Use only Dyson chargers for charging this Dyson appliance.
• The battery is a sealed unit and under normal circumstances poses no
safety concerns. In the unlikely event that liquid leaks from the battery
do not touch the liquid and observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and
seek medical advice.
– Eye contact – can cause irritation. Immediately flush eyes thoroughly
with water for at least 15 minutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of
immediately, following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or chemical
burn if mistreated. Do not disassemble, short contacts, heat above
60°C (140°F), or incinerate. Keep away from children. Do not
disassemble and do not dispose of in fire.
ONLINE SUPPORT
• For online help, general tips, videos and useful information about Dyson.
www.dyson.com/support

DISPOSAL INFORMATION

• Dyson products are made from high grade recyclable materials.
Recycle where possible.
• Before disposing of the appliance, remove the battery from
the appliance;
– When the battery is removed, the appliance must be powered off;
– The battery should be safely disposed of.
• Dispose of or recycle the battery in accordance with local ordinances
or regulations.
• Dispose of the exhausted filter unit in accordance with local ordinances
or regulations.
GUARANTEE TERMS AND CONDITIONS
DYSON CUSTOMER CARE
THANK YOU FOR CHOOSING TO BUY A DYSON APPLIANCE.
After registering your 2 year guarantee, your Dyson appliance will
be covered for parts (excluding filters) and labour for 2 years from
the date of purchase, subject to the terms of the guarantee. However,
indispensable legal rights of the final consumer under applicable
national legislation governing the sale of consumer goods are not
affected by the terms of the guarantee. If you have any queries regarding
your Dyson appliance, visit www.dyson.com/support for online help,
general tips and useful information about Dyson.
Alternatively, you can call the Dyson Helpline with your serial number
and details of where and when you bought the appliance.
If your Dyson appliance needs a repair, call the Dyson Helpline so we
can discuss the available options. If your Dyson appliance is under
guarantee, and the repair is covered, it will be repaired at no cost.
PLEASE REGISTER AS A DYSON APPLIANCE OWNER
To help us ensure that you receive prompt and efficient service, please
register as a Dyson appliance owner. There are two ways to do this:
• By email.
• By calling the Dyson Helpline.
This will confirm ownership of your Dyson appliance in the event of an
insurance loss, and enable us to contact you if necessary.
LIMITED 2 YEAR GUARANTEE
TERMS AND CONDITIONS OF THE DYSON 2 YEAR
LIMITED GUARANTEE.
WHAT IS COVERED
• The repair or replacement of your Dyson appliance (at Dyson's
discretion) if it is found to be defective due to faulty materials,
workmanship or function within 2 years of purchase or delivery (if any
part is no longer available or out of manufacture, Dyson will replace it
with a functional replacement part).
• This guarantee will only be valid if the appliance is used in the country in
which it was sold.
WHAT IS NOT COVERED
Dyson does not guarantee the repair or replacement of an appliance
where a defect is the result of:
• Accidental damage, faults caused by negligent use or care, misuse,
neglect, careless operation or handling of the appliance which is not in
accordance with the Dyson Operating Manual.
• Use of the appliance for anything other than normal domestic
household purposes.
• Use of parts not assembled or installed in accordance with the
instructions of Dyson.
• Use of parts and accessories which are not genuine Dyson components.
• Faulty installation (except where installed by Dyson).