Power Connector Cable - HP 13-be0 Series Maintenance And Service Manual

3. Remove the system board from the computer (2).
Reverse this procedure to install the system board.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 5-13 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the power connector cable:
1. Remove the two Phillips M2.5 × 5.0 screws (1) from the right hinge.
2. Rotate the hinge off the power connector (2).
3. Disconnect the power connector cable from the system board (3).
44 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 29).
29).
Battery on page 31).
Spare part number
M45022-001