Light Bar - HP 13-be0 Series Maintenance And Service Manual

4. Thoroughly clean the thermal material from the surface of the heat sink (1) and the system board
component (2) each time the heat sink is removed. Replacement thermal material is included with the
heat sink and system board spare part kits.
Reverse this procedure to install the heat sink.

Light bar

To remove the light bar, use this procedure and illustration.
Table 5-9 Light bar description and part number
Description
Light bar
Before removing the light bar, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the light bar:
1. Disconnect the cable from the ZIF connector on the light bar (1).
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
29).
Component replacement procedures
Spare part number
M52695-001
29).
39