Wlan Module - HP 13-be0 Series Maintenance And Service Manual

Remove the speakers:
1. Disconnect the speaker cable from the system board (1).
2. Remove the speaker cable from the clips along the bottom of the battery (2).
3. Remove the speakers from the computer (3).
NOTE:
(4).
Reverse this procedure to install the speakers.

WLAN module

To remove the WLAN module, use this procedure and illustration.
Table 5-5 WLAN module descriptions and part numbers
Description
Realtek RTL8821CE-M 802.11ac 1 × 1 Wi-Fi + Bluetooth 4.2
Realtek Wi-Fi 6 RTL8852AE + Bluetooth 5.2
Realtek Wi-Fi 6 RTL8852AE-VT + Bluetooth 5.2
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the WLAN module:
34 Chapter 5 Removal and replacement procedures for authorized service provider parts
When installing the speakers, be sure that the rubber gaskets are installed in the screw holes
To prevent an unresponsive system, replace the wireless module only with a wireless module
Bottom cover on page
Preparation for disassembly on page
29).
Battery on page
Spare part number
M09870-005
M34027-005
M34029-005
29).
31).