Touchpad - HP Chromebook 14 Maintenance And Service Manual

Remove the speakers:
1. Disconnect the speaker cable from the system board (1).
2. Remove the Phillips M2.0 × 5.0 screw (2) that secures each speaker to the computer.
3. Lift the bottom of the speakers up, and then pull the speaker toward the front to remove the tab on top
of the speaker from the slot that holds it in place (3).
4. Disconnect the cable from the ZIF connector on the touchpad (4).
5. Remove the cable from the clips located between the speakers under the battery (5).
Reverse this procedure to install the speakers.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-5 Touchpad description and part number
Description
Touchpad (includes rubber and protective tape)
Touchpad cable (included in Cable Kit)
Touchpad support bracket (included in Bracket Kit)
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the touchpad:
1. Remove the four Phillips M2.0 × 2.5 screws (1) that secure the touchpad bracket to the computer.
26 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page 22).
Battery on page 23).
Spare part number
M35761-001
M34155-001
M12524-001
22).