Touchpad Button Board - HP 240 G7 Maintenance And Service Manual

TouchPad button board

Description
TouchPad button board
TouchPad button board bracket
TouchPad button board cable
Before removing the TouchPad button board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the TouchPad button board:
1. Disconnect the TouchPad ZIF cable from the TouchPad button board (1).
2. Disconnect the system board ZIF cable from the TouchPad button board (2).
3. Remove the two Phillips M2.0×2.0 screws (3) that secure the board to the computer.
4. Lift the bracket from on top of the TouchPad button board (4).
5. Lift the board and then slide it outward from under the clips that hold it on place to remove it (5).
TIP:
prevent damage to the board or clips.
Reverse this procedure to install the TouchPad button board.
40 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page
The top edge of the board sits under clips. Be sure to slide the board out from under the clips to
(Preparation for disassembly on page
27).
29).
Spare part number
L23197-001
L23193-001
L23185-001
26).