Outboard Rigging; Cable, Hose, And Wire Routing - BRP E250DHLSCS Service Manual

INSTALLATION AND PREDELIVERY

OUTBOARD RIGGING

OUTBOARD RIGGING
CAUTION
To prevent accidental starting while servic-
ing, disconnect the battery cables at the
battery. Twist and remove all spark plug
leads.

Cable, Hose, and Wire Routing

Remove two screws and bracket that fasten the
grommet to lower motor cover.
1. Grommet retaining bracket
Route all hoses, control cables, and wiring
through a protective sleeve or conduit into the
boat and through the grommet.
The fuel hose may be routed through the protec-
tive sleeve or through an alternate hole in the
lower motor cover grommet.
To route the fuel hose outside the sleeve, trim the
material covering the alternate fuel hose slot in
the grommet.
1. Alternate fuel hose location
50
Refer to the following diagram to ensure proper
positioning of rigging components in grommet.
1. Fuel supply hose
2. Fuel supply hose--alternate location
3. Oil supply hose
4. Oil tank sending unit harness
5. Battery cables
1
6. Main wire harness (MWS)
7. Shift cable
8. Throttle cable
9. Accessory charge wires
10. CANbus harness
11. Water pressure hose
12. Speedometer hose
003964
1. Alternate fuel hose location
The main wiring harness, battery cables, oil tank
sending unit harness, and any CANbus cables
should be routed along the same path to the star-
1
003970
000095
1
003971