Install external snap rings onto upper pin with
sharp edge facing out.
Place trim/tilt wires in braided tube and install
through hole in the stern bracket.
Attach the ground wire to the trim/tilt unit.
1
1. Ground wire
25064
Release the tilt support and lower the outboard.
Tighten the manual release valve to a torque of 45
to 55 in. lbs. (5.1 to 6.2 N·m).
25079
Install connector on trim/tilt cable and reconnect
trim connectors to engine wire harness.
TRIM AND TILT
TRIM AND TILT SERVICE
25057
27381
14
331