TRIM AND TILT
TRIM AND TILT SERVICE
Remove the external snap rings from the upper
pin.
Use a punch to remove the upper pin.
Retract the tilt cylinder rod.
Remove the external snap rings from the lower
pin.
330
Use a punch to remove the lower pin and remove
the trim/tilt unit from the stern brackets.
25064
Installation
Place trim/tilt unit into position. Apply Triple-Guard
grease to the lower pin and install the pin.
If loosened, tighten the tilt tube nut to a torque of
45 to 50 ft. lbs. (61 to 68 N·m).
Install external snap rings on lower pin with sharp
edge of ring facing out.
25065
Extend tilt cylinder rod to match with holes in
swivel bracket.
Apply Triple-Guard grease to upper pin and install
the pin.
25077
25076
25077