Pinion Bearing; Propeller Shaft Bearing Housing And Forward Gear - BRP E250DHLSCS Service Manual

Slide the propeller shaft onto the shift shaft, align
the hole in the shaft with the hole in the clutch
dog, install the pin and then, a new clutch dog
retaining spring. Place three coils over each end
of the pin, MAKING SURE NONE OF THE COILS
OVERLAP OR ARE LOOSE.
1. Retaining spring

Pinion Bearing

Refer to Pinion Bearing Installation on p. 287.
Propeller Shaft Bearing Housing
and Forward Gear
Disassembly
Remove and discard the bearing housing O-ring.
Remove the anode and discard if more than two-
thirds deteriorated.
Clamp the propeller shaft bearing housing by the
anode bosses in a vise, as shown. Remove the
forward gear bearing housing assembly from pro-
peller shaft bearing housing. Use Spanner
Wrench, P/N 432400, to unscrew in a counter-
clockwise direction.
GEARCASE – COUNTER ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Remove the shim(s).
1
006935
Inspect the forward gear and bearing housing
assembly for excessive wear or damage.
006936
006937
006852
006853
13
305