BRP E250DHLSCS Service Manual page 306

GEARCASE – COUNTER ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Install arms of shift lever into detent slots. Align
the pivot holes and insert the retaining pin. Push
shifter detent down.
TYPICAL
1. Pin, shift lever
Inspect clutch shaft detent balls, retainer and
spring. These parts should not require removal
under normal servicing.
WARNING
Wear safety glasses to avoid injury.
If these parts are damaged or removed, a new
service kit should be installed. Refer to parts cata-
log for kit part number.
1
2
1. Clutch Shaft Retainer Kit
2. Clutch Shaft
304
Coat thrust bearing and thrust washer with Needle
Bearing grease. Place the bearing on the back of
the gear. Set the washer on top of the thrust bear-
ing. Insert the gear, bearing, and washer into the
bearing housing.
1
IMPORTANT:
installed in the correct order.
2
006861
1. Thrust bearing
2. Thrust washer
Align holes in the clutch dog with slot in the pro-
peller shaft. Install the clutch dog on the shaft with
"PROP END" facing rear of the shaft.
IMPORTANT:
cal. If installed backwards, it will not fully engage
and will immediately damage itself and the gears.
0000
1. "PROP END"
Bearing and washer must be
The clutch dog is not symmetri-
1
006905
1
006906