Propeller Shaft Bearing Housing And Gear Installation - BRP E250DHLSCS Service Manual

GEARCASE – STANDARD ROTATION
GEARCASE ASSEMBLY
the driveshaft by hand to thread the nut on to
shaft.
Apply Gasket Sealing Compound to the threads of
the driveshaft bearing housing screws. Tighten
screws in stages to a torque of 120 to 144 in. lbs.
(13.5 to 16.5 N·m).
1
1. Driveshaft bearing housing screws
Use Driveshaft Holding Socket, P/N 311875, Pin-
ion Nut Holder, P/N 334455,
Retainer, P/N 341438, to tighten the pinion nut to
a torque of 100 to 110 ft. lbs. (136 to 149 N·m).
296
Pad handle of holder to prevent damage to gear-
case.
1
006923
1. Holding socket
2. Pinion holder
3. Retainer
Propeller Shaft Bearing Housing
and Gear Installation – "L2" Type
IMPORTANT:
ing on the "L2" type gearcases is PRESSED into
the gearcase housing.
1
Oil and install thrust bearing and thrust washer on
hub of reverse gear.
006876
2
and Wrench
1. Thrust bearing
2. Thrust washer
The propeller shaft bearing hous-
3
2
006875
1
006905