of the pin, MAKING SURE NONE OF THE COILS
OVERLAP OR ARE LOOSE.
1. Retaining spring
Pinion Bearing Removal
Remove pinion bearing retaining screw.
1
1. Pinion bearing retaining screw
2. Water screen pocket
3. Seal
Assemble Pinion Bearing Remover and Installer,
P/N 391257, in the gearcase as follows:
GEARCASE – STANDARD ROTATION
SHIFTER, BEARING AND SEAL SERVICING
Use a 7/8 in. wrench to hold the remover in place.
Use a 3/4 in. wrench to turn flange nut clockwise.
Draw the bearing up from the housing.
1
006907
1. Flange nut, P/N 326586
2. Plate, P/N 391260
3. Rod, P/N 326582
4. Remover, P/N 326579
2
Pinion Bearing Installation
Assemble the following components of Pinion
Bearing Remover and Installer, P/N 391257, as
shown:
3
006892
DRC7416
006893
1. 1/4-20 X 1/2 in. Hex head screw
2. 1 in. O.D. Flat washer
3. Spacer; P/N 350932 "M" and "M2"
P/N 326584 "L" and "L2"
4. Plate and Bearing P/N 391260
5. Rod P/N 326582
6. Installer/Remover, P/N 350958
7. 1/4-20 X 1 1/4 in. Hex head screw
IMPORTANT:
cannot be interchanged.
Spacers are different sizes and
1
2
3
4
DR3419
1
2
3
4
5
6
7
824182
13
287