Gearcase Housing Inspection - BRP E250DHLSCS Service Manual

Remove propeller shaft assembly from gearcase.
Water Intake Screens
Remove and clean water intake screens. Replace
if damaged.
1. Water intake screen
GEARCASE – STANDARD ROTATION

GEARCASE HOUSING INSPECTION

GEARCASE HOUSING
INSPECTION
Thoroughly clean gearcase housing to remove all
dirt and debris prior to inspection. Inspect pinion
bearing and forward thrust surface of gearcase
housing.
Use Gearcase Alignment Gauge Kit, P/N 5006349
to check the condition of gearcase housing prior
to reassembly. Refer to instructions provided with
kit. Use additional Gauging Head as follows:
P/N 5007750, for "L2" Type gearcase housings
006839 •
P/N 5007749, for "M2" Type gearcase housings
•
1
IMPORTANT:
alignment hole. Shaft MUST slide easily into hole
006886
of gauging head. If shaft does not slide into hole,
gearcase housing is damaged and must be
replaced.
1. Gauging shaft
DO NOT force gauging shaft into
006787
1
13
004347
283