Propeller Shaft Bearing Housing Removal - BRP E250DHLSCS Service Manual

Propeller Shaft Bearing Housing
Removal – "L2" and "M2" Type
Identify gearcase type before dis-
IMPORTANT:
assembly. For counter rotation gearcases, refer to
GEARCASE DISASSEMBLY on p. 300.
The propeller shaft bearing housing on "L2" and
"M2" models is PRESSED into gearcase housing.
"L2" T G
YPE EARCASES
Remove the two screws, washers, and retainers
holding the propeller shaft bearing housing.
1. Retainer tab screws
"M2" T G
YPE EARCASES
Remove the two screws holding the propeller
shaft bearing housing.
1. Retainer screws
GEARCASE – STANDARD ROTATION
Remove the propeller shaft bearing housing from
the gearcase using:
Propeller Shaft Bearing Housing Puller Kit,
•
P/N 354060.
DO NOT use tools designed to push on the pro-
peller shaft. Pushing force against the propeller
shaft could damage the forward gear thrust bear-
ing or thrust washer.
IMPORTANT:
adaptor ring included with puller kit.
Install the threaded adaptor from the puller kit on
to the propeller shaft until seated.
1
001989
"M2" Type Gearcase
Assemble puller kit components. Hold adaptor
with wrench and turn nut clockwise to pull bearing
housing.
1
006835
GEARCASE DISASSEMBLY
The L2 type gearcase uses the
006833
006874
13
279