BRP E250DHLSCS Service Manual page 262

Evinrude e-tec series 250, 300 hp 90 v6 (3.4l)

Table of Contents

STERN BRACKET

Remove the anode.

Remove the swivel bracket. Inspect and, if neces-

sary, replace the tilt tube bushings.

1. Tilt tube bushing

Remove the trim sender unit from the port stern

bracket and pull its wires through the braided

Remove the tilt limit switch and retainer from the

swivel bracket.

1. Tilt limit switch

Disconnect the trail lock spring and remove it from

the swivel bracket. Remove trail arm retainer.

1. Trail lock spring

2. Trail arm retainer

Remove the trail lock arm and bushings from the

swivel bracket.

1. Trail lock bushing

Chapters

Table of Contents