BRP E250DHLSCS Service Manual page 258

MIDSECTION
EXHAUST HOUSING
Cleaning Solvent. Apply Gel-Seal II sealant to the
adapter flange of the exhaust housing.
Place the adapter/inner exhaust housing into the
exhaust housing. Guide the water tube through
the hole in the outer housing.
256
Loosely install the small retaining screws, nuts,
and washers.
13692
Lubricate the upper mount with soapy water and
push into place in the adapter housing. The mount
radius must face aft with the "TOP" mark facing
up.
Apply Locquic Primer and Nut Lock to the upper
mount plate screws and install the plate and
screws loosely. Install the ground lead and star
washer under the forward starboard screw.
Align the outer exhaust housing and adapter by
placing two powerhead mounting screws through
their holes.
006981
1
1. Powerhead mounting screws
32580
006985