POWERHEAD
POWERHEAD INSTALLATION
1. Rear powerhead nut
Place the shift rod in the shift rod lever. Install the
retaining pin and washer. Tighten pin to a torque
of 60 to 84 in. lbs. (7 to 9.5 N·m).
1. Shift rod pin
Make sure the gearcase shifts
IMPORTANT:
solidly into both forward and reverse and that pro-
peller shaft spins freely in neutral.
Install water hoses and exhaust back pressure
hose.
2
3
1. Cooling hose (from exhaust plenum)
2. Cooling hose (from vapor separator)
3. Speedometer hose
238
1
2
1
004252
1. Cooling hose (to exhaust plenum)
2. Exhaust back pressure hose (to EMM)
Route power trim harness through clamp and con-
nect to engine harness.
1
2
004241
1. Trim harness
2. Clamp
1
1
1. Trim/tilt connectors
Install flywheel. Refer to FLYWHEEL AND STA-
TOR SERVICING on p. 145.
004239
005042
1
006992
1
004251