Throttle Linkage Installation; Final Powerhead Assembly - BRP E250DHLSCS Service Manual

POWERHEAD
POWERHEAD ASSEMBLY

Throttle Linkage Installation

Apply Nut Lock to threads of throttle lever screw.
Insert spring into cavity of throttle lever.
Install lever, screw, and washer on crankcase and
hook spring on rib as shown. Tighten screw to a
torque of 120 to 144 in. lbs. (13.5 to 16.5 N·m).
1. Throttle lever spring
Apply Nut Lock to threads of throttle cam screw.
Install cam, screw, and washer on cylinder block
and tighten screw to a torque of 120 to 144 in. lbs.
(13.5 to 16.5 N·m).
1
1. Throttle cam screw
Do not lubricate throttle levers or
IMPORTANT:
shoulder screws.
236

Final Powerhead Assembly

Install the reed plate and throttle body assemblies.
Refer to Intake Manifold Service on p. 181.
Install oil recirculating hoses and check valves.
Refer to OIL RECIRCULATION DIAGRAMS – V6
on p. 190, or POWERHEAD VIEWS on p. 240.
Install pressure valve assembly. Refer to PRES-
SURE RELIEF VALVE SERVICING on p. 209.
Install shift linkage. Refer to Shift Linkage Instal-
lation on p. 235.
1
Install throttle linkage. Refer to Throttle Linkage
Installation on p. 236.
Install fuel injectors and ignition coils. Refer to
Fuel Injector Installation on p. 180.
IMPORTANT:
their original location. Improper injector installation
006966
can result in powerhead failure.
Install oil pump, rear oil manifold, and oil injection
hoses. Refer to OIL COMPONENT SERVICING
on p. 198.
Install stator. Refer to FLYWHEEL AND STATOR
SERVICING on p. 145.
Install electrical harness and EMM. Refer to EMM
SERVICING on p. 108.
Install fuel pump assemblies, fuel manifolds, and
filter. Refer to FUEL COMPONENT SERVICING
on p. 174.
Install the electric starter. Refer to Starter Instal-
lation on p. 155.
006866
To prevent fire and explosion hazard,
make sure all electrical and ignition wiring
is routed and clamped in original posi-
tions.
All injectors must be reinstalled in
WARNING