Apply Permatex No. 2 to crankcase flange screws
where threaded hole is open to crankcase.Install
screws and tighten to to a torque of 84 to 108 in.
lbs. (9.5 to 12 N·m).
Test that the crankshaft spins freely without bind-
ing.
Apply Nut Lock to the upper and lower crankcase
head screws. Install and tighten screws to a
torque of 96 to 120 in. lbs. (11 to 13.5 N·m).
After
IMPORTANT:
assembled, allow at least two hours for Gel-Seal II
to cure before running outboard.
004138
004142
powerhead
has
been
POWERHEAD ASSEMBLY
Shift Linkage Installation
Lubricate shift linkage bosses at the base of the
crankcase with Triple-Guard grease. Insert bush-
ings into bosses.
Apply Triple-Guard grease to the shaft of the shift
lever assembly. Guide shaft through bushings in
crankcase.
Install shift rod lever and tighten retaining screw
60 to 84 in. lbs. (7 to 9.5 N·m).
Apply Triple-Guard grease to shoulder of shift arm
screw and Nut Lock to threads. Install arm, screw,
and washer and tighten screw to a torque of 120
to 144 in. lbs. (13.5 to 16.5 N·m).
1
1. Shoulder screw
2. Shift rod lever retaining screw
POWERHEAD
2
004145
11
235