BRP E250DHLSCS Service Manual page 234

POWERHEAD
POWERHEAD ASSEMBLY
Lubricate rod cap screw threads and under screw
head mating surface with a light coat of Triple-
Guard grease. Apply outboard lubricant to screw
hole threads in rod, and to screw head mating sur-
face on cap.
Align dot on rod cap with dot on the connecting
rod.
Install rod cap screws finger tight (NO MORE than
6 in. lbs. (1 N·m) maximum).
Be sure alignment dot on rod cap
IMPORTANT:
matches dot on rod and that both dots face fly-
wheel.
1. Alignment dots
Tightening rod cap screws with-
IMPORTANT:
out Alignment Fixture, P/N 396749, or using an
incorrect procedure could cause permanent dam-
age to the connecting rod and crankshaft. To
maintain accurate torque values, keep torque
wrench extension length to a minimum.
232
Install Rod Cap Alignment Fixture, P/N 396749,
before tightening rod cap screws. Align the flat
marked "SET" on the rod adjustment stop with the
arrow on the frame. Position the stop at the high-
est setting (two lines showing). Rotate adjustment
knob 180° to lock the stop in position.
1
1. Adjustment stop, highest setting
Secure restraining jaw "A" and forcing jaw "B" to
frame.
31826
1
Restraining Jaw "A"
53628
Forcing Jaw "B"
2287
21591
21594