BRP E250DHLSCS Service Manual page 230

POWERHEAD
POWERHEAD ASSEMBLY
Lightly coat the outside diameter of a new crank-
shaft seal with Gasket Sealing Compound. Use
Seal Installation Tool, P/N 325453, to install seal
in lower crankcase head with extended lip of seal
facing down. Coat seal lips with Triple-Guard
grease.
1
1. Seal, extended lip
Lightly coat two new O-rings with Gasket Sealing
Compound and install on lower crankcase head.
Keep sealer away from oil passage.
1. Oil passage
Use threaded rods or Guide Rods, P/N 383175, to
align retainer plate with crankcase head. Slide
crankcase head onto crankshaft until seated
around lower main bearing.
228
Install new seals on the four bearing retainer
screws. Apply Nut Lock to the threads of the
screws and tighen to a torque of 96 to 120 in. lbs.
(11 to 13.5 N·m).
DRC5798
Lightly coat the outside diameter of a new upper
seal with Gasket Sealing Compound. Use the flat
end of Seal Installation Tool, P/N 325453, to
install seal flush in upper crankcase head with the
lip facing down. Coat the seal lip with Triple-Guard
grease.
1
004132
1. Seal installer, P/N 325453
000826
000827
1
49597