Cylinder Block Cleaning - BRP E250DHLSCS Service Manual

CYLINDER BLOCK
CLEANING
Before inspecting or assembling
IMPORTANT:
powerhead, all internal components must be com-
pletely clean and free of contaminants.
Remove any carbon accumulation from exhaust
port areas.
Remove any carbon accumulation from cylinder
head combustion chambers.
If cylinder walls are glazed from extended use,
use a rigid, medium grit cylinder hone to resurface
walls. Use slow RPM for best oil retention and ring
sealing. When finished, a cross hatch pattern of
22 to 32° should be visible in the cylinder wall.
The pattern should be uniform in both directions.
To avoid piston or cylinder block
IMPORTANT:
damage, restore the chamfer to all port edges
using a ball hone or other suitable tool.
1
1. Crosshatch pattern in cylinder wall
2. Chamfered port edge
Use Gel Seal and Gasket Remover to remove all
traces of gaskets, adhesives, and Gel-Seal II™
sealant from the cylinder block and crankcase.
To avoid personal injury, wear eye protec-
tion and rubber gloves when using Gel
Seal and Gasket Remover.
TYPICAL
Carefully remove any carbon accumulation from
the tops and ring grooves of the piston using
Engine Tuner. A ring groove cleaning tool can be
made by breaking an old ring and grinding an
angle on its end. Do not damage ring grooves
2
while cleaning.
Thoroughly wash entire cylinder block and crank-
case with warm, soapy water to remove all traces
of contaminants.
Air dry cylinder block and crankcase. Blow all
holes and passageways with compressed air.
002067
To avoid personal injury, wear eye protec-
tion and set compressed air pressure at
less than 25 psi (172 kPa).
Cover the cylinder walls with a liberal amount of
outboard lubricant to prevent corrosion.
POWERHEAD

CYLINDER BLOCK CLEANING

WARNING
WARNING
34861
11
223