Cylinder Head Removal; Connecting Rods And Pistons - BRP E250DHLSCS Service Manual

Evinrude e-tec series 250, 300 hp 90 v6 (3.4l)

Table of Contents

Separate crankcase and cylinder block. It may be

necessary to tap on crankshaft with a rawhide or

rubber mallet to loosen.

Carefully remove the crankcase from the cylinder

block to avoid damaging the crankshaft seal rings.

Cylinder Head Removal

Loosen in stages and remove cylinder head

retaining screws. Remove the cylinder head.

Use a permanent marker to identify each connect-

ing rod cap, connecting rod, and piston by cylinder

number. Number 1 is closest to the flywheel.

Use Torquing Socket, P/N 346187, to loosen in

stages the rod cap retaining screws. DO NOT

remove the screws.

POWERHEAD DISASSEMBLY

Table of Contents