OILING SYSTEM
OIL COMPONENT SERVICING
Install oil pump on bracket with clamp and retain-
ing screw. Tighten to a torque of 24 to 36 in. lbs.
(3 to 4 N·m).
1
1. Clamp
Reconnect the electrical connector.
Use oil primer bulb to purge air
IMPORTANT:
from oil supply hose before reconnecting hose to
oil pump.
200
Reconnect oil supply hose to the inlet fitting of oil
pump. Fasten with Oetiker clamp.
1. Oil supply hose
2. Oetiker clamp
004220
Make sure oiling system is primed. Check oil flow
through oil distribution hoses. Check oil system
operation and routing of oil hoses. Refer to Oil
Supply Priming on p. 59.
Run the outboard and check for leaks.
Repair any oil leaks and any kinked or misrouted
hoses.
2
1
005519