FUEL SYSTEM
FUEL COMPONENT SERVICING
Inspect the intake manifold. All gasket surfaces
must be cleaned, smooth, and free of nicks. Use a
machinist's straight-edge to check flatness in all
directions. Surface must be flat, ±0.004 in. (0.10
mm).
1
1. Straight-edge
Assembly
Remove old adhesive from reed valve retaining
screws.
Prime screw threads with Locquic Primer and let
dry. Apply Nut Lock to threads. Position reed
valve on reed plate and install screws. Tighten
screws to a torque of 30 to 42 in. lbs. (3.5 to 4.7
N·m).
182
Installation
Place reed plate assembly on cylinder/crankcase.
Apply Nut Lock to screws. Install all screws.
Tighten the center screws first and expand out-
ward. Tighten in stages to a final torque of 96 to
120 in. lbs. (11 to 13.5 N·m).
004193
Place gasket on throttle body. Install throttle body,
with oil pump bracket on reed plate and install
screws.
Tighten the center screws first and expand out-
ward. Final torque is 96 to 120 in. lbs. (11 to 13.5
N·m).
004194
Install crankshaft position sensor.
Install vapor separator vent hose and oil recircula-
tion hose. Secure with tie straps.
004205
004257