Fuel Filter Service - BRP E250DHLSCS Service Manual

Pressure Gauge, P/N 5007100, to top test fitting
of fuel pump/vapor separator assembly.
1
1. Shop towel
Insert venting hose of gauge into a suitable con-
tainer.
Slowly open gauge's venting valve.
Clean up any spilled fuel.
1
1. Test fitting
2. Venting hose
3. Venting valve
FUEL COMPONENT SERVICING

Fuel Filter Service

Removal
Disconnect the battery cables at the battery.
Use an appropriate filter wrench to turn the filter in
a counterclockwise direction. Remove the filter
carefully to prevent spilling the filter's contents.
Inspect contents for any presence of water. If
water is present, identify the source and correct
the problem. Take additional fuel samples and
drain fuel tank(s), if necessary.
004335
1
1. Fuel filter
3
Installation
Lubricate filter seal with outboard lubricant and
position filter on threaded mounting tube of filter
bracket. Take care not to damage water in fuel
sensor probe. Turn filter clockwise onto the tube
2
until seated against the bracket.
004334
Tighten filter approximately 3/4 turn after the gas-
ket contacts the bracket.
Squeeze primer bulb to prime fuel system. Hold
pressure on bulb and check for fuel leaks.
Connect battery cables.
Run outboard and check for fuel leaks.
FUEL SYSTEM
005022
8
175