BRP E250DHLSCS Service Manual page 162

Evinrude e-tec series 250, 300 hp 90 v6 (3.4l)

Table of Contents

ELECTRICAL AND IGNITION

CONNECTOR SERVICING

Terminal Installation

Install wire gasket on wires and feed wires

through the correct terminal position of the con-

nector housing. Terminal is crimped onto wire and

then pulled back into connector housing until lock-

ing tab engages and terminal is seated.

Crimping Terminals

Strip insulation back 3/16 in. (5 mm). Position end

of wire strands in terminal past the wire crimp area

and the end of insulation in the insulation crimp

area of the terminal.

Capture all wire strands in crimp; leave no loose

strands. Crimp wire and insulation securely using

crimping pliers.

Chapters

Table of Contents