BRP E250DHLSCS Service Manual page 153

Remove the two thru-bolts. Mark the end cap ori-
entation, and remove the cap.
Gently tap the starter frame with a rubber mallet to
loosen it.
Find the insulator cap (end of the shaft or inside
the end cap). Inspect and replace, if necessary.
ELECTRIC STARTER SERVICING
Note the alignment marks by the positive terminal
stud. Hold the armature in place, and slide the
frame away from the gear housing.
30365
Slowly remove the armature and thrust washer.
Do not lose the brush springs.
30354B
ELECTRICAL AND IGNITION
30352
7
30351
151