Flywheel Installation - BRP E250DHLSCS Service Manual

ELECTRICAL AND IGNITION
FLYWHEEL AND STATOR SERVICING

Flywheel Installation

Install the outer edge of flywheel key parallel with
centerline of crankshaft.
1. Flywheel key
Thoroughly clean the crankshaft and flywheel
tapers with Cleaning Solvent
Apply a thin, even coat of Nut Lock
taper of the flywheel.
146
1
DRC2116
and let dry.
™
49623
to the inside
™
DO NOT over apply Nut Lock on
IMPORTANT:
flywheel taper. This prevents Nut Lock from
migrating into upper seal of crankshaft.
Align the flywheel keyway and install the flywheel.
Coat the threads of a new flywheel nut with Gas-
ket Sealing Compound. Install the nut and torque
to 140 to 160 ft. lbs. (190 to 217 N·m).
Perform the timing verification
IMPORTANT:
procedure after flywheel removal or replacement.
Refer to TIMING ADJUSTMENTS on p. 147.
DP0567