BRP E250DHLSCS Service Manual page 138

Evinrude e-tec series 250, 300 hp 90 v6 (3.4l)
Table of Contents

Advertisement

ELECTRICAL AND IGNITION
ELECTRIC START CIRCUIT
Start Circuit Operation
The starter must engage and turn the flywheel.
The outboard must crank a minimum of 100 RPM
to start. Normal cranking speed is approximately
175 RPM.
Starter performance depends on the following:
Proper battery and cable capacity.
Clean, tight cable connections.
Solenoid activation through the key switch, neu-
tral safety switch, and EMM.
Refer to Battery Installation on p. 27 for battery,
terminal, and cable requirements.
Solenoid Wiring
The positive (B+) battery cable connects to a large
terminal of the starter solenoid. This terminal also
provides the 12 V power supply to the engine har-
ness (red wire) and the 10 A fuse. The red/purple
wire from the fuse holder (10 A) provides 12 V to
terminal "B" of key switch.
The negative (B–) battery cable connects to the
main ground stud next to starter solenoid.
Engine Wire Harness
Contains the following circuits:
Red/purple output wire from fuse provides 12 V
to instrument harness.
Purple wire provides switched 12 V to solenoid
(terminal "A") and EMM.
Yellow/red wire provides switched 12 V to
EMM.
Brown/white wire from terminal 11 of EMM J1-B
connector provides switched ground (NEG) to
starter solenoid (terminal "B").
136
Instrument Wire Harness
Contains the following circuits:
Red/purple wire provides 12 V to key switch ter-
minal "B".
Purple wire provides switched 12 V to engine
wire harness.
Yellow/red wire from terminal "S" of key switch
provides switched 12 V to EMM (key switch in
START position).
Key Switch, ON position
12 V is applied to the accessory circuit. Key
switch ON:
Switches 12 V to terminal "A" of key switch and
to the purple wires of the wire harnesses.
Provides 12 V input to terminal 21 of EMM J1-B
connector. EMM turns ON.
EMM provides 12 V to terminal "A" of starter
solenoid.
1
B
M
M
M
C
A
A
S
4
5
6
3
2
1
1. Key switch, ON position – Continuity between ter-
minals "B" and "A"
2. Terminal "B", 12 V (Red/purple)
3. Terminal "A", 12 V (Purple)
B
B
M
M
M
C
C
A
S
S
B
M
C
M
A
3
000691
2
S

Advertisement

Table of Contents
loading

This manual is also suitable for:

E250dhxscsE300dpxscsE300dcxscsE300dpzscsE300dczscs

Table of Contents