Electrical Harness Connections - BRP E250DHLSCS Service Manual

ELECTRICAL HARNESS
CONNECTIONS
Inspect wiring and electrical connections. Disas-
semble and clean all corroded connections.
Replace damaged wiring, connectors, or termi-
nals. Repair any shorted electrical circuits. Refer
to wiring diagrams and reference charts for spe-
cific wiring details.
Refer to CONNECTOR SERVICING on p. 156.
Engine Harness to Stator
Connector
Pin
Description of Circuit
No.
1 Stator winding (1S)
2 Stator winding (3S)
3 Stator winding (2S)
4 Stator winding (1F)
5 Stator winding (3F)
6 Stator winding (2F)

ELECTRICAL HARNESS CONNECTIONS

EMM J1-A Connector
Pin
Description of Circuit
No.
1 Oil Pressure sensor
2 Diagnostic connector
3 Diagnostic connector
4 Ground, water in fuel (digital)
5 Oil level switch
6 Crankshaft position sensor (CPS)
7 Ground, CPS (digital)
8 Bootstrap connector (programming)
9 Stop circuit
10 Throttle position sensor (TPS) 5 V
004050
11 Ground (analog)
12 Engine temperature sensor, port
Wire Color
13 CANbus, NET-L
Yellow
14 CANbus, NET-H
Orange 15 Water pressure
16 Tachometer
Brown
17 CHECK ENGINE signal, SystemCheck
Yellow /White
18 TPS
Orange/White
19 Engine temperature sensor, starboard
Brown/White
20 Air temperature sensor
21 CANbus, NET-S
22 CANbus, NET-C
23 Water in fuel
24 NO OIL signal, SystemCheck
25 WATER TEMP signal, SystemCheck
26 Start signal
27 vacant
28 vacant
29 Shift switch (shift linkage)
30 Trim relay, UP
31 Trim relay, DOWN
32 Trim sender, IN
33 Trim sender, OUT
34 LOW OIL signal, SystemCheck
ELECTRICAL AND IGNITION
Wire Color
Tan/White
Red
White
Black
Tan/Black
Yellow
White
Blk/Orange
Blk/Yellow
Red
Black
Pink/Black
Blue
White
Pink
Gray
Tan/Orange
Green
Pink/Black
Pink/Blue
Red
Black
Pink/Green
Tan/Yellow
Tan
Yellow/Red
Black/Yellow
Blue/White
Green/White
White/Tan
White/Tan
Tan/Black
001875
7
127