Table of Contents
Advertisement
INTRODUCTION
SERVICE SPECIFICATIONS
SERVICE SPECIFICATIONS
HP
Full Throttle
Operating Range
Power
Idle RPM in Gear
Test Propeller
Weight
(may vary depending
on model)
Lubrication
Engine Type
Displacement
Bore
Stroke
Standard Bore
Top Crankshaft Journal
Center Crankshaft Journals
Bottom Crankshaft Journal
Rod Crankpin
Piston Ring End Gap, Both
Fuel/Oil Ratio
Starting Enrichment
Preferred Fuel
Acceptable Fuel
Minimum (High) Fuel Pressure
@ IDLE RPM – 500 ± 50
Minimum Fuel Lift Pump Pressure
@ IDLE RPM – 500 ± 50
Maximum Fuel Inlet Vacuum
Minimum Octane
Additives
10
250 H
4500–6000 RPM
250 HP
(187 kw)
@ 5250 RPM
Standard Rotation Models: P/N 436080 or P/N 396277
Counter Rotation Models: P/N 436081 or P/N 398674
20 in. (L) Models: 507 lbs. (230 kg)
25 in. (X) Models: 528 lbs. (239 kg)
30 in. (Z) Models: 534 lbs. (242 kg)
Evinrude/Johnson XD100 Oil
Refer to Oil Requirements on p. 65
90° V 6-Cylinder Loop-Charged
210.0 cu. in. (3441 cc)
3.854 in (97.89 mm)
3.000 in. (76.20 mm)
3.8535 to 3.8545 in. (97.87 to 97.90 mm)
To bore oversize, add piston oversize dimension to standard bore
1.6199 to 1.6204 in. (41.15 to 41.16 mm)
2.1870 to 2.1875 in. (55.55 to 55.56 mm)
1.5747 to 1.5752 in. (40.0 to 40.01 mm)
1.4995 to 1.5000 in. (38.09 to 38.106 mm)
0.022 to 0.028 in. (0.57 to 0.72 mm)
Regular unleaded gasoline
See Fuel Requirements on p. 64 for additional information.
22 to 28 psi (152 to 193 kPa)
4 in. Hg. (13.5 kPa)
87 AKI (R+M)/2 or 90 RON
®
2+4
Fuel Conditioner, Fuel System Cleaner
Use of other additives may result in engine damage.
See Fuel Requirements on p. 64 for additional information.
300
5000–6000 RPM
300 HP
(234 kw)
@ 5500 RPM
500 ± 50
EMM Controlled
EMM Controlled
3 psi (21 kPa)
Advertisement
Chapters
Table of Contents
Troubleshooting
