ENGINE MANAGEMENT MODULE (EMM)
EMM SERVICING
EMM SERVICING
If a new EMM is being installed,
IMPORTANT:
refer to EMM Transfer on p. 107.
Removal
Disconnect exhaust pressure hose and cooling
hoses from EMM.
Disconnect J1-A, J1-B, and J2 connectors.
Remove two EMM retaining screws.
1
1. EMM mounting screws
Lift EMM away and to the starboard side.
108
Installation
Align slots in starboard side of EMM case with iso-
lator mounts on cylinder block. Slide EMM into
position.
2
1. EMM mounting slots
2. Isolator mounts
1
Install two EMM retaining screws. Tighten screws
12 to 16 in. lbs. (1.5 to 2 N·m).
006967
1
1. EMM mounting screws
Install J1-A, J1-B, and J2 connectors.
Install exhaust pressure hose and cooling hoses.
Secure with tie straps.
1
006968
1
006967