Solid-State Drive (Ssd) - HP 14s Maintenance And Service Manual

Solid-state drive (SSD)

Description
512 GB, TLC
256 GB, TLC
128 GB, TLC
256 GB, value
128 GB, value
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
40 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page
Solid-state drives are designed with notches to prevent incorrect insertion.
32).
34).
Spare part number
763008-013
760615-041
759848-022
865902-013
827560-042