HP 14-BS0 Series Maintenance And Service Manual page 71

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the WLAN module (see
8. Remove the memory module (see
9. Remove the solid-state drive (see
To remove the system board:
1. Position the computer upright, and then disconnect the following cables from the system board:
(1): USB board cable
(2): Display cable
(3): Power connector cable
(4): Power button board cable
(5): TouchPad cable
(6): TouchPad button board cable
(7): Keyboard cable
2. Remove the three Phillips PM2.5×3.5 screws (1) that secure the system board to the computer.
Battery on page 32).
Optical drive on page
Bottom cover on page
WLAN module on page
Memory module on page
Solid-state drive (SSD) on page
34), if installed.
41).
43).
45).
51).
Component replacement procedures 63