Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
7.
Remove the display (see
To remove the power connector cable:
1.
Disconnect the cable from the system board (1).
2.
Lift the tape that secures the connector to the computer (2).
3.
Remove the cable from the clips around the fan (3), and then lift the power connector cable from the
computer (4).
Reverse this procedure to install the power connector cable.
Battery on page
30).
Optical drive on page
Bottom cover on page
Display assembly on page
31), if installed.
34).
61).
Component replacement procedures
Spare part number
813505-001
69
Hide quick links:
Advertisement
Table of Contents
