HP 240 G4 Maintenance And Service Manual page 65

● WLAN module (see
Memory module (see
●
To remove the system board:
1. Remove the display and antenna cables by disconnecting the display cable from the system board (1).
2. Disconnect the antenna cable from the WLAN module (2).
3. (Touch models only) Disconnect the touch cable from the system board (3).
4. Remove the cables from the clips in the middle of the computer (4).
5. Remove the cable from the clips near the battery bay (5).
6. Remove the tape that secures the cables to the computer (6), and then remove the cables from their
remaining routing paths.
WLAN module on page 41)
Memory module on page 43)
Component replacement procedures 57