Table of Contents
Advertisement
3.
Lift the right side of the system board (2), and then pull the board up and to the right to remove it (3).
Reverse this procedure to install the system board.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
Before removing the display panel, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the heat sink (see
Remove the display assembly:
1.
Remove the plastic that covers the integrated WLAN module (1), and then disconnect the antennas from
the module (2).
2.
Disconnect the camera cable (3).
3.
Disconnect the display cable (4).
4.
Remove the display cable from the clip at the top of the chassis (5).
40
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
27).
Heat sink on page
33).
26).
26).
Advertisement
Table of Contents
