Elkay EZTL Series Installation And Use Manual
Versatile bi-level water coolers
Hide thumbs
Also See for EZTL Series:
- Installation, care & use manual (11 pages) ,
- Installation and use manual (10 pages) ,
- Installation instructions manual (8 pages)
Advertisement
Quick Links
EZSTLG8*1C, LZSTLG8*1C,
INSTALLATION AND USE MANUAL
Manual de instalación y uso
Manuel d'installation et utilisation
EZTL
& LZTL
Series Versatile Bi-Level Water Coolers
™
™
EZTL
& LZTL
Serie versátil bi-nivel enfriadores de agua
™
™
EZTL
& LZTL
Série versatile refroidisseurs d'eau à deux niveaux
™
™
Versatile Cooler Models EZSTLG8L and
LZSTLG8L configuration as shipped
Versatile Cooler Models EZSTL8GL and
LZSTL8G8L alternate installation
PAGE 1
1000002034 (Rev. A - 07/18)
Advertisement
Related Manuals for Elkay EZTL Series
Summary of Contents for Elkay EZTL Series
- Page 1 EZSTLG8*1C, LZSTLG8*1C, INSTALLATION AND USE MANUAL Manual de instalación y uso Manuel d’installation et utilisation EZTL & LZTL Series Versatile Bi-Level Water Coolers ™ ™ EZTL & LZTL Serie versátil bi-nivel enfriadores de agua ™ ™ EZTL & LZTL Série versatile refroidisseurs d’eau à deux niveaux ™...
- Page 2 EZSTLG8*1C, LZSTLG8*1C, Note: Danger! Electric shock hazard. Disconnect power before servicing unit. Nota: peligro! Peligro de descarga eléctrica. Desconecte antes de reparar la unidad. Remarque : Danger ! Risque d'électrocution. Débrancher avant de réparer l'appareil. Uses HFC-134A refrigerant Usa refrigerante HFC-134A 14, 25 Utilise du fluide frigorigéne HFC-134A See Figure 6...
- Page 3 EZSTLG8*1C, LZSTLG8*1C, FIG. 2 PAGE 3 1000002034 (Rev. A - 07/18)
- Page 4 EZSTLG8*1C, LZSTLG8*1C, FIG. 3 1000002034 (Rev. A - 07/18) PAGE 4...
- Page 5 EZSTLG8*1C, LZSTLG8*1C, Versatile Wrapper and Trim Kit Installation Instructions Left Hand Wrapper (High Side) Right Hand Wrapper 1) Remove existing wrapper (Low Side) by removing the (4) screws 1) Remove existing wrapper from bottom. by removing the (4) screws 2) Screw trim piece to wrapper from bottom.
-
Page 6: Entretien
EZSTLG8*1C, LZSTLG8*1C, HANGER BRACKETS INSTALLATION INSTALACIÓN DE SOPORTES PARA COLGAR SUPPORTS DE CROCHET DE SUSPENSION INSTALLATION Retire el soporte fijador que se encuentra conectado a 1) Remove hanger brackets fastened to back of cooler la parte posterior del enfriador sacando un (1) tornillo. by removing one (1) screw. - Page 7 EZSTLG8*1C, LZSTLG8*1C, Service Instructions Lower and Upper Shroud To access the refrigeration system and plumbing connections, remove four screws from bottom of cooler to remove the lower shroud. To remove the upper shroud for access to the pushbars, regulator, solenoid valve or other components located in the top of the unit, remove lower shroud, disconnect drain, remove four screws from tabs along lower edge of upper shroud, unplug two wires and water tube.
- Page 8 EZSTLG8*1C, LZSTLG8*1C, NOTE: When installing replacement bubbler and pedestal, tighten locknut only to hold parts snug in position. Do Not Overtighten. NOTA: Al instalar el grifo y pedestal de reemplazo, apriete la tuerca unicamente para mantener las piezas en una Basin posicion adjustada.
- Page 9 PRINTED IN U.S.A. IMPRESO EN LOS E.E.U.U. INFORMATIONS POUR LE SERVICE PAR NUMERO SANS FRAIS 1.800.260.6640 IMPRIMÉ AUX É.-U. ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484 • www.elkay.com PAGE 9 1000002034 (Rev. A - 07/18)