600KL-BT ASSEMBLY INSTRUCTIONS (continued)
7. Set the base/pillar assembly upright.
Obtain the display head module. Plug the
cable labeled "SCALE" into the SCALE
jack in the display module. Plug the cable
labeled "COM" into the COM jack in the
display module.
8. Place the display module on top of the
pillar and align the tab on the front of the
pillar with the slot at the bottom of the
display module.
9. Remove the screw from the back of the
display module, place the module on top of
the pillar and use a Phillips screw driver to
replace and tighten the screw securing the
display head to the pillar.
9
Pillar tab