Set Up - Health O Meter 600KL-BT User Instructions

SET UP

Set Up
1. Remove the protective film from the display window on the display head.
2. Ensure the scale base is on a stable, level and flat surface and that the sides of the base are
clear of any obstacles.
3. Utilizing the leveling bubble located at the top of the scale platform, level the scale by
adjusting the leveling feet at each corner of the underside of the base.
Powering the Scale
1. For greater flexibility the scale offers two options for attaching the AC adapter and both are
equally acceptable. The AC adapter can be plugged into the base of the scale and into the
power source/outlet. The AC adapter can also be plugged into the "DC IN" plug on the back
of the display module and then into the power source/outlet.
Note: The Auto Off function is only active when the scale is being used without the AC adapter.
2. For battery operation, see Battery Installation below.
Battery Installation
1. Place the scale on its side. The battery holder is located in the center of the bottom of the
base.
2. Slide the battery cover in the direction of the "open" arrow.
3. Place the 6 C-cell batteries into the battery holder. Note the orientation that is shown and
ensure the batteries are placed in the proper direction. Do not use zinc-carbon batteries.
4. Replace the battery cover.
Note: When powering the scale via batteries, the AC adapter must be disconnected from the
scale.
Warning: If the scale will not be used for some time, remove all batteries to avoid a safety hazard.
Disposal of batteries should be done according to the national, regional or local regulations.
Battery compartment
(underside of scale platform)
10