Malfunctions; Detail Description Of Status Indications - Record C 127 X SU H-B OFFSET User Manual

7

Malfunctions

7 Malfunctions
7.1

Detail description of status indications

General
In case of an irregularity, the display changes automatically from operation mode level to error dis-
play. Depending on the control unit connected BDE-E or BDE-M various indications are given.
When using an electronic BDE-D
The background colour changes between normal/invers every 2 seconds. Several errors can be dis-
played (e.g. 1/2 means: Error No. 1 of total 2 errors).
Status notifications with a „W" are warnings. In this case, the error relay does not switch. The status
can be reset by several means according to the detailed description.
A status can usually be deleted by pressing the key
start in the control unit.
Information about the operator system, like e.g. the software version, can be read out of the BDE-D
main display by pressing the same key once again (for two seconds).
Telephone number, fault and maintenance are only displayed, when this function has been activated
by the service technician.
If the cause of the fault has not been eliminated, however, the status message will re-appear if the
fault occurs again.
The following list gives the causes of faults in decreasing probability. The fault at the bottom of the list
has the smallest probability of occurring in the STG.
Press key about 2 seconds
Browse through informations by tapping the key
28 / 32
Temporary return to main display for 4 seconds after browsing through error dis-
plays.
BAL_C127_X_SU_H-B_OFFSET_EN_1V1_REC_121-006454632
for 5 seconds (= reset). This triggers a re-