Touchpad - HP Chromebook x360 14c Maintenance And Service Manual

3. Disconnect the cable from the ZIF connector on the touchpad (3). You need to move this cable so that
you can remove the speaker cable that routes under it.
4. Remove the speaker cable from the clips in the computer chassis (4).
5. Remove the two Phillips M2.0 × 5.0 screws (5) that secure the speakers to the computer.
NOTE:
screw holes (6).
6. Remove the speakers from the computer (7) .
Reverse this procedure to install the speakers.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-4 Touchpad description and part number
Description
Touchpad
Touchpad cable
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
When installing the speakers, be sure that the gaskets are correctly installed in the speaker
(Bottom cover on page
Battery on page
(Preparation for disassembly on page
21).
23).
Spare part number
M00314-001
M00308-001
21).
Component replacement procedures 25